MkII-B ARM-R Rail Assembly - Carbine
Price: $279.00
Quantity:

MkII-B ARM-R Rail Assembly - Carbine

Our ARM-R carbine Length Rail Kit. This three piece rail kit is made from 6065 series aluminum that is Type III mil-spec hardcoat anodized in black. The kit consists of three main pieces: 1) Lower section that contains the 3, 6, and 9 o'clock rails, 2) The rail clamp that attaches the system to the upper receiver, and 3)The removable top rail, which attaches to the lower section via hardened steel pins and 'J' shaped cuts that are found on the rail. These hooks and pins allow a 100% return to zero when removing and replacing the top rail. The top rail is held in place by pusher screws, which seat against special high-temp rubber o-rings.

The removable top rail allows the user easy access to the piston components on a piston operated gun or to the gas tube on a direct impingement gun. The top rail can be removed and replaced without tools other than the rim of a cartridge case. This rail kit fits any standard mil-spec upper receiver without any special mounting hardware.

Two Quick Detach swivel mounts (one fore and one aft on both 3 and 9 o'clock positions) accommodate most Uncle Mike's® pattern QD sling swivels. Rails are T-Marked on all four sides for quick location of accessories. This lightweight and durable rail system has made LWRC rifles and carbine the go-to choice for the operator that needs plenty of 1913 Picatinny mounting surfaces for optics, lights, bipods, and lasers.
WARNING: Observe safe firearm handling practices at all times. Failure to do so may result in serious bodily injury or death. LWRC International shall not be responsible for injury, death, or property damage resulting from faulty installation, misuse, illegal use, or modification of this product.

EXPORT NOTICE: This product and/or its components is subject to the International Traffic in Arms Regulations (ITAR, 22 CFR Parts 120-130) and export is strictly prohibited without authorization or a license issued by the U.S. Department of State's Directorate of Defense Trade Controls. Additionally, any documents or engineering drawings, prints, etc. that can be viewed, downloaded, or printed from our Web site may contain technical data which may not be Exported outside of the United States, or released or disclosed to non-US persons (i.e. persons who are not US citizens or lawful permanent residents) inside of the United States, without prior written authorization by the relevant US Government agency. Violations of these export laws are subject to severe civil, criminal and administrative penalties.